The pressure is recorded by a pressure transducer(s) capable of recording slow and fast (at least 1000 points sec.

There's a transformer too... Just turn this thing here... and iron.

The transformer got struck by lightning again.

But inside a standard transformer are two coils of wire.

Coolant pressure tester Mechanics tool chest

Pressure receptacles may not be equipped with any pressure relief device.

Don t Cripple the Tigers

This shall be at least two thirds of the design pressure of the aerosol dispenser.

These transformers contained PCBs in the form of Askarel ... .

4.1.3.6 Pressure receptacles for liquids and solids

Rubber is not hard it gives way to pressure.

This box can be used to change the pressure of the gas.

(a) Each plug or valve shall have a taper threaded connection directly to the pressure receptacle and be capable of withstanding the test pressure of the pressure receptacle without damage or leakage

Pressure can make everything whole again.

(iii) Pressure sensors, pressure activated mechanisms, should, where possible, be subject to a minimum pressure force appropriate for the intended target.

4.1.3.6.3 Unless otherwise indicated, pressure receptacles having a minimum test pressure of 0.6 MPa shall be used.

Leaking or severely deformed aerosols shall be transported in salvage packagings provided appropriate measures are taken to ensure there is no dangerous build up of pressure.

Compressed Data Transfer

(iii) Pressure sensors shall, where possible, be subject to a minimum pressure force appropriate for the intended target.

Each pressure receptacle with a wall thickness at any point of less than 2.0 mm and each pressure receptacle that does not have fitted valve protection shall be transported in an outer packaging.

The pressure vessel should be in compliance with the requirements for the gas(es) contained in the pressure vessel.

Pressure receptacle repairs shall meet the requirements of 4.1.6.1.11.

6.2.4.2.2.2 Pressure and leak testing of aerosol dispensers before filling

The pressurized section is designed to be attached to the pressurized module and to carry and store the payload required for intravehicular activity.

Pressure receptacles shall not be manifolded or interconnected. .

The DPSIR framework states that driving forces exert pressures on the environment and that these pressures can induce changes in its state or condition.

The electricity subsector was severely affected by Hurricane Luis, with damage to poles, lines, transformers and other equipment.

It's really just a pressure sensor like the kind that's in a doorbell.

We're developing alternative powertrains that are going to make cars affordable in every sense of the word economically, socially and environmentally.

Transmitter

Pressure receptacles may be used provided that the general provisions of 4.1.3.6 are met.

Pressure receptacles may be used provided that the general provisions of 4.1.3.6 are met.

Pressure receptacles may be used provided that the general provisions of 4.1.3.6 are met. .

When we finally got out the back door, transformers were burning in the street.

It reads the shifting conditions of temperature, humidity, wind direction, wind speed, dew point, and it processes this data in a central computer that calibrates the degree of water pressure and distribution of water throughout.

Every empty aerosol dispenser shall be subjected to a pressure equal to or in excess of the maximum expected in the filled aerosol dispensers at 55 C (50 C if the liquid phase does not exceed 95 of the capacity of the receptacle at 50 C).

4.1.3.6.7 Prior to filling, the filler shall perform an inspection of the pressure receptacle and ensure that the pressure receptacle is authorized for the substances to be transported and that the provisions of these Regulations have been met.

(4) Pressure receptacles may be used provided that the general provisions of 4.1.3.6 are met.

(1) Pressure receptacles may be used provided that the general provisions of 4.1.3.6 are met.

(5) Pressure receptacles may be used provided that the general provisions of 4.1.3.6 are met.

Prepare descomopresión camera.

Mr. Wolfensohn I should tell you, Mr. President, that two of our buildings have just been evacuated because of explosions in the transformers, which were to set the scene for me for this meeting.

This finds expression in resisting the pressure to conform to a changing society.

The new compression value of JPEG images to be sent

This entry applies to fuel cell cartridge design types shown without their packaging to pass an internal pressure test at a pressure of 100 kPa (gauge).