I have been under a lot of pressure lately.

Tom has been under a great deal of strain lately.

Test pressure means the maximum gauge pressure at the top of the shell during the pressure test

In Table 1, in the heading of column 13, replace Working pressure, bar with Maximum working pressure, bar

The first feature of the new engine is... its greatly increased ratio of compression... represented by R minus 1 over R to the power of gamma... where R represents the ratio of compression and gamma...

(b) has a minimum burst pressure of 4 times the charge pressure at 20 C

Too much pressure on my nerves.

MAWP _ bar kPa gauge

Test pressure _bar kPa gauge The unit used shall be marked.

The pressure relief devices shall open automatically at a pressure not less than the MAWP and be fully open at a pressure equal to 110 of the MAWP.

The pressure relief devices shall open automatically at a pressure not less than the MAWP and be fully open a pressure equal to 110 of the MAWP.

Girl 2 That would be so stressful.

I haven't been very pleasant this weekend. We've all been a little tense lately.

Two thirds of them were women, who bore the brunt of the burden of poverty and hunger.

It's a lot of work.

Heavy on the foot, Frankie.

(i) the maximum effective gauge pressure to which the shell is designed as defined in (b) of the MAWP definition (see above) and

(iii) Pressure sensors, pressure activated mechanisms, should, where possible, be subject to a minimum pressure force appropriate for the intended target.

4.1.3.6.3 Unless otherwise indicated, pressure receptacles having a minimum test pressure of 0.6 MPa shall be used.

The pressurized module will provide an environment of one atmospheric pressure.

The bursting pressure of the disk fixed to the 10 l vessel should be equal to the maximum rupture pressure of the bursting disks to be fitted to the IBC or tank.

115. There are mounting environmental pressures on urban areas all over the world, but they are felt most strongly in Asia s rapidly changing cities.

(iii) Pressure sensors shall, where possible, be subject to a minimum pressure force appropriate for the intended target.

Which makes for a very can make for a very stressful situation.

Critical incident stress management

This box can be used to specify the units of pressure, e. g. atmospheres, bars, etc.

MAWP for heating cooling system _ bar kPa gauge

Test pressure means the maximum gauge pressure at the top of the shell during the hydraulic pressure test equal to not less than 1.5 times the design pressure.

And in the review, what they were interested in seeing is what kind of stresses most reliably raise levels of cortisol, the central stress hormone.

I'll try to recover my position as your champion.

Headquarters has given them the push.

Wouldn't it be a terrible strain for you?

Not ill, really. More a matter of nervous strain, I think.

Vents or pipes from the pressure relief device outlets, when used, shall deliver the relieved vapour or liquid to the atmosphere in conditions of minimum back pressure on the relieving devices.

Pipework to vent the vapour or liquid from the outlet of the pressure relief devices, when used, shall deliver the relieved vapour or liquid to the atmosphere in conditions of minimum back pressure on the relieving device.

See MAWP definition in 6.6.3.1

Specifically, if you look on the vertical axis, that's stress. If you look at the maximum stress value for each of these fibers, you can see that there's a lot of variation, and in fact dragline, or major ampullate silk, is the strongest of these fibers.

TP16 The tank shall be fitted with a special device to prevent under pressure and excess pressure during normal transport conditions.

That would have meant too much pressure.

6.6.2.8.5 When the shell is fitted for pressure discharge, the inlet line shall be provided with a suitable pressure relief device set to operate at a pressure not higher than the MAWP of the shell, and a stop valve shall be fitted as close to the shell as reasonably practicable.

6.6.3.8.1 The combined delivery capacity of the relief devices shall be sufficient that, in the event of total fire engulfment, the pressure (including accumulation) inside the shell does not exceed 120 of the MAWP.

Vents from the pressure relief devices, when used, shall deliver the relieved vapour or liquid to the atmosphere in conditions of minimum back pressure on the relieving device.

Every empty aerosol dispenser shall be subjected to a pressure equal to or in excess of the maximum expected in the filled aerosol dispensers at 55 C (50 C if the liquid phase does not exceed 95 of the capacity of the receptacle at 50 C).

Now, the deeper you go underwater, the higher the pressure is.

The nuclear non proliferation regime is under huge pressure.