4.1.3.6.3 Unless otherwise indicated, pressure receptacles having a minimum test pressure of 0.6 MPa shall be used.

TP14 The minimum test pressure shall not be less than 1.5 times the vapour pressure at 65 C or 10 bar, whichever is greater.

Pressure drums shall have a minimum wall thickness as specified by the competent authority.

This pressure should be lower than the test pressure of the tank involved.

(b) has a minimum burst pressure of 4 times the charge pressure at 20 C

I have been under a lot of pressure lately.

Test pressure means the maximum gauge pressure at the top of the shell during the pressure test

The pressure relief devices shall open automatically at a pressure not less than the MAWP and be fully open at a pressure equal to 110 of the MAWP.

The pressure relief devices shall open automatically at a pressure not less than the MAWP and be fully open a pressure equal to 110 of the MAWP.

Moonyukoff the streets and be with him.

Tom has been under a great deal of strain lately.

Test pressure means the maximum gauge pressure at the top of the shell during the hydraulic pressure test equal to not less than 1.5 times the design pressure.

Vents or pipes from the pressure relief device outlets, when used, shall deliver the relieved vapour or liquid to the atmosphere in conditions of minimum back pressure on the relieving devices.

Pipework to vent the vapour or liquid from the outlet of the pressure relief devices, when used, shall deliver the relieved vapour or liquid to the atmosphere in conditions of minimum back pressure on the relieving device.

In Table 1, in the heading of column 13, replace Working pressure, bar with Maximum working pressure, bar

Vents from the pressure relief devices, when used, shall deliver the relieved vapour or liquid to the atmosphere in conditions of minimum back pressure on the relieving device.

And I'll write this little p here, because that's at constant pressure.

(iii) Pressure sensors, pressure activated mechanisms, should, where possible, be subject to a minimum pressure force appropriate for the intended target.

(iii) Pressure sensors shall, where possible, be subject to a minimum pressure force appropriate for the intended target.

And in the review, what they were interested in seeing is what kind of stresses most reliably raise levels of cortisol, the central stress hormone.

Which of course means Criticism, Rejection, Assholes and Pressure.

Vacuum relief devices, when used, shall have a cross sectional flow area not less than 284 mm2.

For shells with vacuum insulation the test pressure shall not be less than 1.3 times the sum of the MAWP and 100 kPa (1 bar).

UN No. Non refrigerated liquefied gases Max. allowable working pressure (bar) Small Bare Sunshield Insulated

The first feature of the new engine is... its greatly increased ratio of compression... represented by R minus 1 over R to the power of gamma... where R represents the ratio of compression and gamma...

It's simply a matter of pressure and counterpressure.

He's coming into the stretch, the pressure's on and he knows.

(b) the maximum effective gauge pressure to which the shell is designed which shall be not less than the sum of

The pressure is recorded by a pressure transducer(s) capable of recording slow and fast (at least 1000 points sec.

(iii) a head pressure determined on the basis of the dynamic forces specified in 6.6.2.2.12, but not less than 0.35 bar.

(ii) a head pressure determined on the basis of the dynamic forces specified in 6.6.2.3.2.9, but not less than 0.35 bar

Pressure

Prescale

Edit brush preset

Pressure?

And don't crush them.

In the case of pressure receptacles for UN 1001 acetylene, dissolved and UN 3374 acetylene, solvent free, at least one decimal shall be shown after the decimal point and two digits for pressure receptacles of less than 1 kg .

(d) the lowest set pressure of the pressure limiting device(s).

Holding time means the time that will elapse from the establishment of the initial filling condition until the pressure has risen due to heat influx to the lowest set pressure of the pressure limiting device(s)

Ethyl chloride Ethylene oxide with nitrogen up to a total pressure of 1MPa (10 bar) at 50 C

I haven't been very pleasant this weekend. We've all been a little tense lately.

So there he is with his little laptop computer, but fighting against the might of the pressures because of the debt, the foreign debt of Ecuador fighting the pressure of World Bank, IMF, and of course the people who want to exploit the forests and take out the oil.

MAWP _ bar kPa gauge

Test pressure _bar kPa gauge The unit used shall be marked.

The bursting pressure of the disk fixed to the 10 l vessel should be equal to the maximum rupture pressure of the bursting disks to be fitted to the IBC or tank.