Design pressure means the pressure to be used in calculations required by a recognized pressure vessel code.

This shall be at least two thirds of the design pressure of the aerosol dispenser.

Pressure vessel code to which the shell is designed

There's a transformer too... Just turn this thing here... and iron.

Pressure receptacles may not be equipped with any pressure relief device.

Even small impacts on pressure vessels may result in container ruptures.

Prepare descomopresión camera.

You pump it at a high pressure through a nozzle.

Highpressure area here, low pressure here.

Trimage image compressor

The pressure is recorded by a pressure transducer(s) capable of recording slow and fast (at least 1000 points sec.

Also, high stress inhibits oxytocin.

The system provided for a high compression ratio of up to 10 1 for speech and of up to 6 1 for fax.

3353 AIR BAG INFLATORS, COMPRESSED 2.2 280 GAS or AIR BAG MODULES, COMPRESSED GAS or SEAT BELT PRETENSIONERS, COMPRESSED GAS

I have high blood pressure.

Arterial hypertension

Coolant pressure tester Mechanics tool chest

The transformer got struck by lightning again.

The frangible disc shall rupture at a nominal pressure 10 above the start to discharge pressure of the relief device.

The frangible discs shall rupture at a nominal pressure 10 above the start to discharge pressure of the relief device.

Tom has high blood pressure.

If your high pressure hose pipe, or your high pressure hydraulic line, bulges a little, you just wrap some tape around the outside of it.

Provision is made in the amount of 30,500 for replacement of items such as an electric suction pump, autoclave and metal case for autoclave, suction pump recharging adapter, surgical knives, amputation equipment, surgical clothing and vacuum mattress.

The packaging shall be adequately ventilated to prevent the creation of flammable atmosphere and the build up of pressure.

Would the ring jumped up to the sky?

The second type is the piezoelectric biosensor.

Come on, boy, the coffin.

The pressurized section is designed to be attached to the pressurized module and to carry and store the payload required for intravehicular activity.

6.6.2.9.2 The required pressure relief device shall be set to start to discharge at a nominal pressure of five sixths of the test pressure for shells having a test pressure of not more than 4.5 bar and 110 of two thirds of the test pressure for shells having a test pressure of more than 4.5 bar.

But inside a standard transformer are two coils of wire.

4.1.3.6 Pressure receptacles for liquids and solids

Down converter, 24 to 12 VDC

This entry applies to fuel cell cartridge design types shown without their packaging to pass an internal pressure test at a pressure of 100 kPa (gauge).

Oh, my lands, my blood pressure.

Of good ink. The bill is very high.

(a) Each plug or valve shall have a taper threaded connection directly to the pressure receptacle and be capable of withstanding the test pressure of the pressure receptacle without damage or leakage

(iii) Pressure sensors, pressure activated mechanisms, should, where possible, be subject to a minimum pressure force appropriate for the intended target.

4.1.3.6.3 Unless otherwise indicated, pressure receptacles having a minimum test pressure of 0.6 MPa shall be used.

Robotic Air Powered Hand with Elastic Ligaments.

(iii) Pressure sensors shall, where possible, be subject to a minimum pressure force appropriate for the intended target.

High pressure builds over India.

18 ft. high pressure steam cleaner

Nothing but you and a flock of high tension wires.

Didn't you know she had high blood pressure?

As far as light weapons are concerned, the situation is slightly different, owing to the higher pressures of the stronger charges fired. The strain on essential parts of the weapon, such as barrels, bolts and receivers, is much greater.