16. Propellant elimination actions should also be designed to relieve high pressure gases employed in pressure fed propulsion systems.

You must breathe the air at the same water pressure around you.

They shall be subjected to an initial test and periodic tests every 10 years at a pressure of not less than 1MPa (10 bar) (gauge pressure).

Stress testing is applied to baseline scenarios in order to take into account vulnerability factors.

So we bring people into a lab, and they do either high or low power poses again, they go through a very stressful job interview.

They shall be made of steel and shall be subjected to an initial test and periodic tests every 10 years at a pressure of not less than 1MPa (10 bar, gauge pressure).

They shall be made of steel and subjected to an initial test and periodic tests every 10 years at a pressure of not less than 0.6MPa (6 bar, gauge pressure).

(c) Cross border kidnapping for ransom, in order to exert pressure, or for similar ends

When performing the constant pressure test, variations in atmospheric pressure shall be taken into account.

Moreover, repatriation has frequently involved various forms of pressure or duress.

It's simply a matter of pressure and counterpressure.

4.1.3.6.7 Prior to filling, the filler shall perform an inspection of the pressure receptacle and ensure that the pressure receptacle is authorized for the substances to be transported and that the provisions of these Regulations have been met.

The pressure is recorded by a pressure transducer(s) capable of recording slow and fast (at least 1000 points sec.

After local residents tried to pressure the Government to take action, authorities announced that the site would be upgraded.

When that pressure faded, so did the political progress.

Other new pressures stemmed from the Corporate Social Responsibility (CSR) process.

Processing folder compression and encryption

Pressure

Prescale

Edit brush preset

Pressure?

4.1.3.6.6 Unless otherwise indicated pressure receptacles shall be subjected to a periodic inspection and test every 5 years.

Under pressure from the family a second autopsy was carried out, and this gave the cause as cerebral and pulmonary oedema .

But doesn t the banks ability to raise new equity capital indicate that, regardless of whether the stress tests are reliable, investors believe that their assets value does significantly exceed their liabilities?

Owing to demographic pressure and women entering the labour force, the region has one of the highest rates of new entrants into the labour market.

This pressure should be lower than the test pressure of the tank involved.

The Meteorological rockets observe temperature, atmospheric pressure, wind etc, at altitudes of between 30 and 60 kilometres.

Enterprises in industries with excess capacity have a larger pressure of debt repayment. De capacity and de leveraging today means to promote the gradual removing of debt risks, said Xu Gao.

Forget the pressure.

(i) managing stress,

Mouse pressure

Too much pressure on my nerves.

Pressure you ?

Meanwhile, I appeal to Member States to maintain pressure on all relevant parties to ensure that the repatriation process gets under way without further delay.

Numerous allegations had been received concerning the excessive use of force by the police or military in carrying out arrests during demonstrations, which had led to numerous deaths.

Those kind of stresses have a very particular effect on the physiology of stress.

(b) has a minimum burst pressure of 4 times the charge pressure at 20 C

And put the pressure where the pressure needs to be put.

Possession of anti State broadcast material or sharing them with others is now criminalized, perhaps to retaliate against external pressures media.

CA Fracking.

14. International pressure

Pressurized tanks open.

Test pressure means the maximum gauge pressure at the top of the shell during the pressure test

Alternatively, the test can be performed in a bunker provided with sufficient ventilation and vent openings to prevent pressure build up in it.

This shall be at least two thirds of the design pressure of the aerosol dispenser.